Power Switch; Handle Adjustment - Uline SANITAIRE EON QUIET CLEAN Manual Del Usuario

6. Insert wand with handle grip and hose into channel
at the back of vacuum. Place handle grip over tab
to latch into position. (See Figure 5)
Figure 5
7. Smooth end of hose. It should fit loosely into wand.
CAUTION! Vacuum is designed to be used on
multiple types of carpeting. Do not attempt to
use with the brushroll operating on bare floors,
as damage to the floor covering may result.

POWER SWITCH

1. Plug electrical cord into outlet.
2. Press down bottom of power switch to turn on.
Expect a short delay when turning the vacuum
cleaner on. Press down top of power switch to turn
off. (See Figure 7)
Figure 7
Off
On
PAGE 4 OF 27
ASSEMBLY CONTINUED
8. Push remaining hose end into hose inlet. Inlet clip
will lock hose into place when fully inserted.
(See Figure 6)
9. Squeeze clip on both sides to remove hose.
(See Figure 6)
Figure 6
10. Check placement of crevice tool and upholstery tool.
Both tools fit into recesses in the back of vacuum.
11. Attach extension cord to quick change power cord.
Press cord into clip to secure the connection.
12. Snap extension cord into cord clip on handle. Wrap
cord around upper and lower cord retainers.
OPERATION

HANDLE ADJUSTMENT

1. Step on handle release pedal to lower handle into
desired position). (See Figure 8)
2. Vacuum can lay completely flat for cleaning under
low furniture.
3. Lower handle without stepping on handle release
pedal to raise the brushroll/nozzle over thresholds.
(See Figure 8)
Figure 8
0421 IH-7147