Temperature Alarm - Teka RVU 10020 GBK Manual Del Usuario

OPERATING YOUR WINE COOLER/BEVERAGE COOLER
 Control System Instruction

① " " Button
To control this appliance turn on/off
3 seconds).

② " " Button
To control the inner light turn on/off.

③ " " Button
Used to raise(warm) the temperature in 1℉（1℃）.

④ " " Button
Used to lower(cool) the temperature in 1℉（1℃）.

⑤ "ο"
Indicator light illuminates to signify the cooling mode is currently in operation.

⑥ "DISPLAY"
To shows the set temperature.
 Setting The Temperature Controls
Set the desired cooling temperature by pressing the buttons adjacent to the"
Each press of the buttons will scroll through the available temperature settings in increments of 1°C.
The temperature setting can be adjusted from 5℃ to 18℃.

If you want to reveal actual temperature, please press and hold the " UP " or " DOWN " button for 3
seconds, the LED will flash and display the actual temperature. After stopping pressing the button for 5
seconds, LED figure will stop flash, then revert back to display the set temperature.
Flashing LED = Cabinet temperature
Steady LED = Set temperature
Replaceable (LED only) light source by a professional
This product contains a light source of energy efficiency class G.
 Temperature Alarm
If the temperature inside is higher than 23
alarm / buzzer will sound. This indicates that the temperature inside is too high. If the temperature inside is lower than
℃
0 , it will display "LO" on the display panel and at the same time the alarm also malfunction indicator is active.
AND SETTING THE TEMPERATURE CONTROL
( press and hold this buttons for approximately
℃
, it will display "HI" on the display panel, and after one hour after the
29
" or " " indicators.