Possible Cause; Retail And Spare Parts And Relevant Documentation - BSVILLAGE SP 3600 Manual Del Usuario

PROBLEM
5. The product
does not work.
6. Water leak.
7. Loss of water from
mechanical seal.
8. Blocked rotor.

9. Retail and spare parts and relevant documentation.

See Tab. 3 with reference to Fig. 19.
Replace any damaged and/or worn components as quickly as possible; use only original spare parts.

POSSIBLE CAUSE

The thermal pro-
tector has been
triggered.
The thermal pro-
tector has been
triggered.
The bearing are
worn out.
Gaskets or o-rings
incorrectly installed
A mechanical seal is
used to isolate the
pump body and the
motor body. Some
drops of water may
flow out once in a
while this is normal,
especially after peri-
ods of non use
Foreign bodies
block the rotating
elements of the
product (impeller or
cooling fan).
Blocked drive shaft,
it can happen after
a long period of
inactivity.
MANUALE_SP3600_BWT-A5 - Rev: 01/2020
1° SOLUTION
Check that the water
temperature does
not exceed +35 [°C]
and, if necessary,
add cold water to the
pool to lower water
temperature.
Blocked drive shaft,
follow the instruc-
tions in Blocked
rotor.
Replace the bearing
Check correct gasket
and o-ring installa-
tion, see Fig. 19, # 1,
2, 3, 4, 5.
If the leaks are consistent Please contact
specialised technicians..
Remove any foreign
bodies.
Do the following:
1. unplug the prod-
uct from the power
outlet;
2. make the drive
shaft turn 9-10 times,
using a screwdriver
as shown in Fig. 18;
3. insert the power
plug of the product
into the power outlet.
EN
2° SOLUTION
Contact specialised
technicians.
Contact specialised
technicians.
Contact specialised
technicians.
TAB. 7
23