Speed Control; Mode Of Operation - EINHELL VENTURRO 18/210 Manual De Instrucciones Original

If the battery pack fails to charge, check:
•
whether there is voltage at the socket outlet
•
whether there is good contact at the charging
contacts
If the battery pack still fails to charge, send
•
the charger
•
and the battery pack
to our customer service center.
To ensure that items are properly packaged
and delivered when you send them to us,
please contact our customer service or the
point of sale at which the equipment was
purchased.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
Battery capacity indicator (Fig. 10)
Press the button for the battery capacity indicator
(Item A). The battery capacity indicator (Item B)
shows the charge status of the battery using 3
LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED fl ashes:
The battery is empty, recharge the battery.
All LEDs blink:
The battery temperature is too low. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.
Anl_Venturro_18_210_SPK13.indb 20 Anl_Venturro_18_210_SPK13.indb 20
GB
6. Operation
Danger!
Start up the equipment only when fully assem-
bled.
6.1 Sizing the strap
Slip the harness over your shoulder and adjust
the length of the harness so that you can handle
the equipment comfortably.
Caution: Wear the harness in such a way that
the snap fastener is always close to hand. In
an emergency you can always remove the
equipment quickly by opening the snap fas-
tener (Fig. 11 / Item 5a).
6.2 Switching the machine On/Off (Fig. 12)
•
To switch on, press the On/Off switch (Item 1).
•
To switch off, let go of the On/Off switch.

6.3 Speed control

The equipment is fi tted with a variable speed
trigger. To use it, turn the speed controller (Fig. 12
/ Item 2) to the desired position. Use the device
only with the speed which is actually required and
do not let it run at a speed which is faster than
necessary.
MIN = Minimum speed
MAX = Maximum speed

6.4 Mode of operation

Caution! Search the surface for concealed ob-
jects (e.g. small animals or hard foreign bodies)
before starting to use the equipment.
6.4.1 Blowing foliage
Caution!
If you point the air fl ow towards other people, ani-
mals or objects (e.g. windows), this could cause
injuries and damage.
•
Point the air flow away from yourself.
•
Never point the air flow towards other people,
animals or objects.
•
Do not blow away any hard objects such as
stones or twigs.
•
Turn the selector lever (Fig. 12 / Item 13) into
the position shown. You can do this regard-
less of whether the tool is running or not.
•
Channel the air stream forward and walk
slowly to blow foliage or garden refuse into a
pile or to clear out hard-to-reach places.
- 20 -
13.01.2022 14:32:41 13.01.2022 14:32:41