Volkswagen Zubehör 5G0 054 809 Manual De Montaje página 15

 Remove the centre console insert -5- and the centre console cover -6- on the driver side.
 ELSA; repair group 68
 Remove the left centre console switch module -4- or the right centre console switch module (not illustrated).

ELSA; repair group 96
Page 2 - Figure 2
 Remove the onboard supply control unit -J519-.

ELSA; repair group 97
Note
The onboard supply control unit does not have to be removed completely. To connect the supplied wiring harness to
the connector only connector "C" -3- needs to be removed from the onboard supply control unit.
Page 2 - Figure 3
Note
The short wire ends of the supplied wiring harness are connected to the plug on the centre console switch module.
 Unlock the centre console switch module plug.
 Engage the crimp connection on the yellow wire in chamber 3 of the plug -Arrow A-.
 Engage the crimp connection on the black/grey wire in chamber 6 of the plug -Arrow A-.
 Lock the centre console switch module plug.
 Connect and lock the plug on the supplied centre console switch module.
 Fit the centre console switch module.
 ELSA; repair group 96
 Route the wiring harness to the onboard supply control unit plug (see. page 2, Fig. 1) and fix to the existing wires
or brackets to prevent rattling noises.
Page 3 - Figure 1
 Unlock and open the onboard supply control unit plug.
 Engage the crimp connection on the yellow wire in chamber 34 of the plug -Arrow A-.
 Engage the crimp connection on the black/grey wire in chamber 21 of the plug -Arrow B-.
 Close/lock the onboard supply control unit plug and connect it to the onboard supply control unit (see page 2, Fig. 2).
 Fit the onboard supply control unit -J519-.
 ELSA; repair group 97
1.3 Concluding work and activation of the driving profile selection
 Fit all vehicle parts in reverse order.
 ELSA
Note
It must be ensured that the open-circuit voltage of the vehicle battery is at least 12.5 Volts. To maintain the onboard
◆
voltage during the procedure, connect a -VAS590X- battery charger.
The request for the vehicle configuration (SVM code) only occurs once if the procedure and test operation is carried
◆
out without any errors. Unprompted multiple requests may generate error messages and have no effect on the
configuration.
 When the ignition is switched off, connect the vehicle diagnostics tester with ODIS service to the vehicle
diagnostics socket.
 Switch on the ignition.
 Select the "Guided Fault Finding" mode and then identify the vehicle.
 After the control units request to change to "Special functions" and start the test program "Function activation
system".

Select push-button "Activate function".
 Enter the diagnostics address "19" (for the control unit to be activated) on the screen and follow the vehicle
diagnostic tester instructions.
After activation, the online connection is established and the software update carried out.
 After successful activation, restart the infotainment system (for this press the On/Off switch of the infotainment
system for more than 10 seconds or wait for the bus to go into stand-by).
 End guided fault finding.
 Terminate the connection to the vehicle diagnostics tester.
 Carry out a function check of the driving profile selection.
 Car handbook
15