Uline H-9635 Manual Del Usuario página 3

8. Fasten tabletop to mounting plates with four
wood screws using a Phillips screwdriver or
10 mm wrench. (See Figure 5)
NOTE: For additional security, attach two remaining
wood screws to side panel mounting plate.
(See Figure 5)
9. Using a 10 mm wrench, attach front panel shelf
mount to front panel on each end by inserting one
M6 x 30 mm hex bolt and one M6 flat washer into
threaded nut. (See Figure 5)
NOTE: Place at same height as back panel
shelf mount.
NOTE: Workbench shown without tabletop.
Figure 5
Mounting
Plates
Front Panel
Shelf Mount
10. Insert the bottom shelf panels. They should sit on the
lower shelf lip. (See Figure 6)
11. Insert the center shelf panels with the cut sections
facing the back left and back right corners of the
cabinet. (See Figure 6)
Figure 6
Bottom
Shelf Panels
PAGE 3 OF 24
ASSEMBLY CONTINUED
Side Panel
Mounting Plate
Center
Shelf Panels
12. Disassemble door handle. Reassemble door handle
with lock bar. (See Figure 7)
Figure 7
13. Position upright on back corner of tabletop. The
upright mounting plate should be positioned directly
over the previously drilled holes. Insert four
M6 x 70 mm bolts and M6 washers through uprights,
tabletop and workstation frame. Using 10 mm
wrench, secure with M6 flange nuts on underside of
table. Repeat for additional upright. (See Figure 8)
Figure 8
Upright
M6 x 70 mm
Bolt
Washer
Flange
Nut
Leg
Lock Bar
Mounting
Plate
Upright
0322 IH-9635