Steam Function - Espressione EM-1040 Manual De Instrucciones

English
Switch the machine on by turning the START/STOP (h7) button to the right to the (I) setting.
The TEMPERATURE light (h6) flashes.
Wait until the TEMPERATURE light (h6) stops flashing.
Place a cup or bowl under the adjustable spout and make sure it is correctly positioned.
Turn the control button to HOT WATER
When the required quantity of water is reached, turn the rotating control button to PENDING ( ) to
stop the flow of hot water (Fig.4) .
The pump stops immediately and the spout circuit is closed.
IMPORTANT
It is possible that some steam may be released from the water tank. This is completely normal.
You can now use the water collected to prepare your hot drink.

3. STEAM FUNCTION

Steam production is ideal for making the milk froth used in milk drinks (cappuccino, latte machiatto, hot
chocolate, etc.).
Check the water level in the tank.
Make sure that the frothing nozzle is securely fitted to the adjustable spout.
Check that the rotating control button is set to PENDING
Switch the machine on by turning the START/STOP (h7) button to the right to the (I) setting.
The TEMPERATURE light (h6) flashes.
IMPORTANT
If the rotating control button (d) is not at PENDING ( ), the TEMPERATURE light (h6) flashes
quickly and heating does not occur.
Turn the TEMPERATURE SELECTION button (h5) to STEAM
Wait until the TEMPERATURE light (h6) stops flashing.
Place a container or empty cup under the spout.
Open the spout circuit by turning the control button to STEAM
may be in the circuit.
Turn the control button back to the left to PENDING ( ).
Pour the milk into a container and plunge the frothing spout into the container without touching the
bottom to pevent blocking the steam flow.
Advice
For a better result, use refrigerated milk, a cold stainless steel container and measure approximately
20 to 30 ml of milk per drink.
Wait until the TEMPERATURE light (h6) stops flashing.
Turn the control button back to STEAM
IMPORTANT
You will then hear an intermittent noise which is the pump jump starting. This is completely normal
and necessary for the steam production. A little steam may be released from the water tank. This
is completely normal.
IMPORTANT
To prevent blocking the flow of steam, the spout should not touch the bottom of the container.
18
. The hot water flows through the spout.
( ).
.
release any remaining water that
.