Safety And Visual Warnings - Espressione EM-1040 Manual De Instrucciones

If a layer of limescale should form on the tank walls, descale using a mixture of water and white vinegar.
Allow it to sit for 1 hour.
Wipe with a non-abrasive sponge and rinse thoroughly.
Cleaning the appliance body, the cup warming plate, the warming
plate and the lid
These parts of the appliance are cleaned using a non-abrasive and slightly wet cloth.
If you notice any traces of coffee on the warming plate, clean using a sponge and a little dish washing
liquid.
Important
Take care not to allow water on the control panel.
Any other servicing should be performed by an authorized service representative.

SAFETY AND VISUAL WARNINGS

The EXPRESSO/HOT WATER/STEAM buttons on the EM-1040 include a general safety device that
prevents confirmation of any operation if the correct temperature has not been reached:
- While the TEMPERATURE light (h4) flashes, none of the buttons (except START/STOP and FILTER
COFFEE) can be used.
Important
The machine is also equipped with visual warnings informing of any misuse of
the machine.
Scenario 1: detection of a fault in the ESPRESSO water tank
In EXPRESSO or HOT WATER mode, w hen the TEMPERATURE light (h6) flashes quickly and the pump
stops, your machine has detected that the water in the tank is at the minimum level and warns you as if
the tank was empty.
In this case:
1. Turn the rotating control button – if this is not the case – to the PENDING position ( ).
2. Switch the machine off by turning the START/STOP button (h7) to the ( ) setting.
3. Empty the rest of the water in the tank and re-fill then re-position correctly.
4. Switch the machine on by turning the START/STOP button (h7) to the (I) setting.
5. Wait until the TEMPERATURE light (h6) stops flashing.
6. Let the water run through the HOT WATER/STEAM spout (fig.3) for approximately 20 seconds
(See section "Hot water function" page 17).
Note:
If the pump has not started completely, the TEMPERATURE light (h6) flashes again (quickly or
normally).
In this case, switch the machine off again. Wait a few seconds then turn on again and restart. It
may be that you have to repeat these operations 2 or 3 times for the pump to be completely
operational again.
Scenario 2: rotating selector incorrectly positioned
If the TEMPERATURE light (h6) flashes quickly when you turn your machine on, this means that the rotating
control button (d) is not set to PENDING ( ) and that the thermo block cannot be heated.
In this case, turn the control button to PENDING ( ).
English
25