Battery Maintenance; Hydraulic Oil - Upright AB-46 Bi-Energy Manual Del Operador

Ocultar thumbs Ver también para AB-46 Bi-Energy:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Maintenance
TIRES
Tire selection can affect the stability of the machine.
Use only tires supplied by UpRight unless approved by
the manufacturer in writing.
BATTERY CHARGING
Charge batteries only in a well ventilated area.
Hazard of explosive gas mixture. Keep sparks,
flame and smoking materials away from
batteries.
Always wear safety glasses when working with
batteries.
Battery fluid is highly corrosive. Rinse away any
spilled fluid thoroughly with clean water.
Always replace batteries with UpRight batteries
or manufacturer approved replacements weighing
120 lbs. each.
Charge batteries as follows:
1. Check the batteries fluid level. If the electrolyte level
is lower than
3
/
in. (10 mm) above the plates, add
8
clean, distilled water only.
2. Verify charger voltage switch is set to the correct
voltage.
3. Connect extension cord (minimum 12 gauge
(1.5 mm²) conductor and maximum 50 ft. (15 m) in
length) to charger plug located through the opening in
front of the chassis (see figure 7). Connect extension
cord to properly grounded outlet of proper voltage
and frequency.
4. The charger will turn on automatically.
5. When the batteries are fully charged, the charger will
turn off automatically .
Ammeter
Figure 7: Battery Charger
All manuals and user guides at all-guides.com

BATTERY MAINTENANCE

Check battery fluid level daily, especially if work platform
is being used in a warm, dry climate.
If electrolyte level is lower than
plates add distilled water only. DO NOT use tap water it
will shorten battery life.
Keep terminals and top of battery clean.

HYDRAULIC OIL

1. Check oil level at dipstick and/sight gauge inside
2. Lift flap located on top of chassis right side (see
3. Open filler / breather cap.
4. If necessary, fill to capacity with clean ISO 46
5. Replace cap.
LUBRICATION
Refer to service manual for lubrication chart and
guidelines.
AC Cord
9
engine compartment right hand side with the platform
fully lowered.
figure 9).
compatible hydraulic oil.
Figure 8: Batteries (Typical Both Sides)
Fuel Filler /
Breather Cap
Oil Level
Sight Gauge
Figure 9: Hydraulic Oil Filler / Breather Cap, Fuel
Filler / Breather Cap, and Oil Level Sight Gauge
3
/
in. (10 mm) above
8
Battery Disconnect
Hydraulic Oil Filler /
Breather Cap

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

1000

Tabla de contenido