Publicidad
14
14
NAIL
(49 used in this step)
Carefully turn your unit over onto its front edges. Unfold the BACK (I) and lay it over your unit.
Make equal margins along all four edges of the BACK (I). Push on opposite corners of your unit if needed to make it "square".
Fasten the BACK (I) to your unit using the NAILS (1N).
NOTE: Be sure to tap NAILS into the holes that line up over the UPRIGHTS (C and D) and BACK BRACE (X).
NOTE: Perforations have been provided for access through the BACK. Carefully cut out the holes needed.
Page 18
These holes must line up over the
UPRIGHTS and BACK BRACE.
1N
www.sauder.com/services
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
I
Cut-out (used for lifting)
414942
Publicidad
