Step1: Connect The Speakers - Onkyo TX-8220 Manual De Instrucciones

SN29403245_TX-8220_En.book 8 ページ ２０１７年７月１１日 火曜日 午後５時４９分
> Before Start > Part Names

Step1: Connect the Speakers

Install
5/8˝
(15 mm)
a Speaker Cable
8
All manuals and user guides at all-guides.com
> Install > Playback
a
*
Right Left
Speaker A
You can connect two systems, Speaker A and Speaker B,
as the Speaker System. When connecting only one set,
connect to the SPEAKERS A terminals. With one set, use
speakers with 4 ≠ to 16 ≠ impedance.
Note that when connecting to both SPEAKERS A and B
terminals, connect speakers with 8 ≠ to 16 ≠ impedance to
both A and B.
Connect the speaker cable so the wires do not protrude
from the speaker jacks. If the exposed wires of the
speakers touch the rear panel or the + and – wires touch
each other, the protection circuit will be activated.
(*)You can also connect a powered subwoofer to the
a
Right Left
Speaker B
Setup
0 When connected as a Speaker B System, you
can output the same audio as Speaker A System
by switching with A/B/A+B. Press SPEAKER A/B
on the main unit to switch. The selection changes
in the order SPEAKER A, SPEAKER B,
SPEAKER A+B, Off with each press.
0 If any of the connected speakers have an
impedance of 4 ≠ or more to less than 6 ≠, or
when a Speaker B system is to be used, press
SETUP (P7) on the remote controller, and set "SP
Impedance" to "4 ohm".
SUBWOOFER PRE OUT jack to boost bass playback
even more. Use a subwoofer cable for connection.
Setup | Others