Step2: Connect The Speakers - Onkyo TX-NR474 Manual De Instrucciones

> Before Start > Part Names

Step2: Connect the Speakers

b
a Speaker cable, b Subwoofer cable
14
> Install > Initial Setup
1/2˝
(12 mm)
a
> Playback
Advanced Setup | Supplementary Information | Others
Make correct connection between the unit's jacks and
speaker's jacks (+ to + and - to -) for each channel. If
connection is wrong, reverse phase may make bass output
poor.
Setup
0 Settings for the speaker configuration you have
connected need to be made in "1. AccuEQ Room
Calibration" in Initial Setup (P20).
0 If any of the connected speakers have an
impedance of 4 ≠ or more to less than 6 ≠, after
completing Initial Setup, you need to make some
settings in the Setup menu. Press
remote controller, select "2. Speaker" -
"Configuration" and set "Speaker Impedance" to
"4ohms".
Connect the speaker cable so the wires do not protrude from the
speaker jacks.
If the exposed wires of the speakers touch the rear panel or the +
and - wires touch each other, the protection circuit will be
activated.
on the