Installing Or Removing Saw Chain; Installing The Saw Chain - Makita UA002G Manual De Instrucciones

6. Loosen the lock ring by turning the lock ring coun-
terclockwise, then extend the pipe approximately 10
cm (3-15/16") or more, and then tighten the lock ring by
turning the lock ring clockwise.
1
3
Fig.12
► 1. Lock ring 2. 10 cm (3-15/16") or more 3. Pipe
7. Insert the pipe into the head of the tool all the way,
and then align the hole on the pipe with the hole on the
head of the tool.
Fig.13
► 1. Hole 2. Pipe
8.
Tighten 2 bolts using the hex wrench.
1
Fig.14
► 1. Bolt
2
1
2

Installing or removing saw chain

CAUTION:
The saw chain and the guide bar
are still hot just after the operation. Let them cool
down enough before carrying out any work on
the tool.
CAUTION:
Carry out the procedure of install-
ing or removing saw chain in a clean place free
from sawdust and the like.

Installing the saw chain

To install the saw chain, perform the following steps:
1. Loosen the chain adjusting screw, then the retain-
ing nut.
Fig.15
► 1. Retaining nut 2. Chain adjusting screw
3. Sprocket cover
2. Remove the sprocket cover.
3. Check the direction of the saw chain. Match the
direction of the saw chain with that of the mark on the
tool body.
Fig.16
► 1. Mark on chain saw body
4.
Fit one end of the saw chain on the top of the
guide bar. Fit the other end of the saw chain around the
sprocket. Make sure that the saw chain is properly fitted
on the sprocket and properly fitted in the groove of the
guide bar.
12 ENGLISH
1 2 3
1