Removing Clogs - Titan T9500 Manual Del Usuario

The vacuum cleaner creates suction that picks up dirt. Rapidly moving air carries the dirt to
traps the dirt.
occasionally for clogs. Turn off and unplug vacuum cleaner from outlet before checking.
TO CHECK FOR CLOGS:
· Check dust bag and change if full. See BAG CHANGING (page 29-30).
(page 31) and EXHAUST FILTER CHANGING (page 31-32).
· Check motorized nozzle for any dirt or debris in the belt path area or in the agitator area.
Carefully remove any string or debris located on the agitator or end caps. See TO CLEAN
AGITATOR (page 35).
If the vacuum cleaner still has poor suction, do the following:
1. Connect the hose to the canister and turn vacuum cleaner on. Check the end of the hose
for suction. If there is good suction on the hose handle, there is no clog in the hose. If
the suction is bad, remove any dirt or debris in the hose and handle.
2. Connect hose handle to wand. Check the end of the wand for suction. If there is good
suction at the end of the wand, there is no clog in the wand. If the suction is bad, remove
any dirt or debris in the wand.
3. Check nozzle swivel. Remove any dirt or debris.

REMOVING CLOGS

-28-
★ ) areas
Motor
Safety
Exhaust
Filter
Filter
DUST
BAG