Disinfecting; In Boiling Water - Pari PEP S Sysem Instrucciones De Uso

DRYING:
Ensure that there is no residual moisture remaining in the com-
ponents. If necessary:
• Shake the water out of all of the parts.
• Place all parts on a dry, clean and absorbent surface, and
allow them to dry completely.

4.5 Disinfecting

Disinfect all individual parts after cleaning. Only components
that have been cleaned can be disinfected effectively.
The validated disinfection procedures are described below.

In boiling water

EQUIPMENT:
– Clean cooking pot
– Drinking water
PROCEDURE:
CAUTION
Risk of infection due to moisture
Moisture encourages the growth of bacteria.
• Remove all parts from the pot as soon as the disinfection
process is finished and allow them to dry.
• Place all the individual parts in water at a rolling boil for at
least 5 minutes. NOTE! Risk of damage to plastic parts!
Plastic will melt if it comes into contact with the hot base of
the pot. Make sure there is enough water in the pot to pre-
vent the individual parts from touching the pot base.
– 22 –