Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning:
The brush cutter must be carefully cleaned after each use.
Clean the engine by hand (avoid introducing water into the
air filter and exhaust). Avoid wetting the controls and other
equipment / accessories that are difficult to dry (water
stimulates the appearance of corrosion and rust);
Do not use aggressive cleaning products. These products
may damage plastics and metals, compromising the safe
operation of the brush cutter.
In order to avoid the risk of fire, the ventilation slots and the
exhaust must remain free of flammable waste.
Maintenance:
Only maintenance works described in this instruction
manual may be carried out; all other works must be
performed by an official distributor.
Only use accessories, oils or greases authorized by VITO.
Not doing so may result in personal injuries or damages to
the brush cutter. In case of doubt, you should contact an
official distributor.
For safety reasons, the fuel conductive components (fuel
hoses, tank, tank cap and couplings) should be checked
regularly for damage and leaks. If necessary, they should
be replaced by an official distributor.
Keep warning and information stickers always clean and
legible.
Keep all nuts and bolts well tightened in order to ensure a
safe operation.
If any components or safety devices are removed for
maintenance
tasks,
immediately.
they
must
be
repositioned
Never store the wheeled brush cutter with petrol in the tank
inside a building. Petrol vapours may come into contact
with flames or sparks and ignite.
Store the brush cutter in a dry area with the fuel tank empty
and the fuel in a well-ventilated compartment.
places with high humidity to avoid the appearance of
corrosion and rust.
Clean the equipment thoroughly before storage, especially
in winter. Keep the device in a good operating condition.
Make sure the appliance is protected against misuse (for
example, by children).
Your brush cutter should only be serviced by the
manufacturer's internal service personnel, or other
qualified personnel, replacing any necessary parts with
original parts sourced directly from the manufacturer).
Insert the wheels (15) into the shafts on the brush cutter's
base frame (14) and tighten with a nut.
Pay attention to the direction of rotation of the wheels. Do
not overtighten the nuts to prevent the wheels from getting
stuck.
The end of the column (11) where the mini support wheel is
located is the one that should connect to the brush cutter's
base frame (14).
1. Align the hole of the column (11) with the hole in the
base frame of the brush cutter (14);
2. Insert a bolt and tighten with a nut;
3. Insert the knob bolt into one of the adjustment holes and
tighten with a nut;
4. Place the spring end of the mini support wheel in the
smallest hole.
Avoid
Publicidad
