Multitab Function - Kuppersbusch IG447.0E Manual De Instrucciones

3. If you use a washing programme with
prewash phase, put more detergent in
the prewash detergent compartment (B).
B
4. If you use detergent tablets, put the de-
tergent tablet in the detergent dispenser
(A).

Multitab function

The multitab function is for combi detergent
tablets.
These tablets contain agents such as deter-
gent, rinse aid and dishwasher salt. Some
types of tablets can contain other agents.
Do a check if these tablets are applicable for
the local water hardness. Refer to the in-
structions from the manufacturer.
When you set the multitab function, it stays
on until you deactivate it.
The multitab function stops automatically the
flow of rinse aid and salt. The rinse aid indi-
cator light and salt indicator light are deacti-
vated.
The programme duration can increase if you
use the multitab function.
Activate or deactivate the multitab func-
tion before the start of a washing pro-
gramme.
You cannot activate or deactivate the
multitab function when the programme
operates. Cancel the washing pro-
gramme, then set the programme again.
To activate the multitab function:
A
5. Close the lid of the detergent dispenser.
Press the lid until it locks into position.
Different brands of detergent dissolve in
different times. Some detergent tablets
do not have the best cleaning results
during short washing programmes. Use
long washing programmes when you
use detergent tablets to fully remove the
detergent.
• Press the multitab button. The multitab in-
dicator light comes on.
To deactivate the multitab function:
• Press the multitab button. The multitab in-
dicator light goes off.
Do these steps if the drying results
are not satisfactory:
1. Fill the rinse aid dispenser with rinse
aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position
2.
• You can only activate or deactivate
the rinse aid dispenser when the mul-
titab function is activated.
To activate the rinse aid dispenser
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press and hold function buttons B and C.
– The indicator lights for function buttons
A, B, and C start to flash.
4. Press function button B.
11