Setting And Starting A Washing Programme - Kuppersbusch IG447.0E Manual De Instrucciones

12
– The indicator lights for function buttons
A and C go off.
– The indicator light for function button B
continues to flash.
5. Press function button B again.
– The end-of-programme indicator light
comes on. The rinse aid dispenser is
active.
6. Switch off the appliance to save the op-
eration.
To deactivate the rinse aid dispenser do the
above steps until the end-of-programme in-
dicator light goes off.

Setting and starting a washing programme

Set the washing programme with the
door ajar. The washing programme only
starts after you close the door. Until then
it is possible to modify the settings.
Do these steps to set and start a washing
programme:
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press one of the programme buttons.
Refer to the chapter 'Washing pro-
grammes'.
– The programme indicator light comes
on.
– The phase indicator light for the wash-
ing programme starts to flash.
4. Close the door.
– The washing programme starts auto-
matically.
– When the programme starts, only the
phase in progress indicator light stays
on.
When the washing programme oper-
ates, you cannot change the pro-
gramme. Cancel the washing pro-
gramme.
You can select the washing programme
also with the door closed. When you
press a programme button you have on-
ly 3 seconds to select a different wash-
ing programme. After these 3 seconds,
the selected programme starts auto-
matically.
Warning! Only interrupt or cancel a
washing programme if necessary.
To use normal detergent again:
1. Deactivate the multitab function.
2. Fill the salt container and rinse aid
dispenser.
3. Adjust the water hardness setting to
the highest level.
4. Do a washing programme without
dishes.
5. Adjust the water softener to the wa-
ter hardness in your area.
6. Adjust the rinse aid dosage.
Caution! Open the door carefully. Hot
steam can come free.
Interrupting a washing programme
Open the door.
• The programme stops.
Close the door.
• The programme continues from the point
of interruption.
Cancelling a washing programme
1. Press and hold function buttons B and C
until the programme indicator light goes
off.
2. Release function buttons B and C to can-
cel the washing programme.
At this time you can do these steps:
1. Switch off the appliance.
2. Set a new washing programme .
Fill the detergent dispenser with detergent
before you set a new washing programme.
End of the washing programme
• The appliance stops automatically.
• The end-of-programme indicator light
comes on.
• The indicator light of the ended pro-
gramme stays on.
1. Switch off the appliance.
2. Open the door.
3. For better drying results, keep the door
ajar for some minutes before you remove
the dishes.
Let the dishes cool down before you remove
them from the appliance. Hot dishes are
easily damaged.