Control Elements; Mounting The Iu0U Automatic Charger; Mounting Instructions - Waeco PerfectCharge IU1012 Instrucciones De Uso

_910-012PFC.book Seite 22 Mittwoch, 21. Juni 2006 4:12 16
PerfectCharge IU1012
5.1

Control elements

Item
in 1, page 3
1
2
3
4
5
6
6

Mounting the IU0U automatic charger

6.1

Mounting instructions

If you wish to mount the IU0U automatic charger in a fixed position, please
observe the following mounting instructions:
You can mount the IU0U automatic charger either horizontally or vertically.
Do not mount the IU0U automatic charger
– In wet or damp environments
– In the vicinity of combustible materials
– In areas where there is a danger of explosions.
The place of installation must be well-ventilated. A ventilation system
must be present for installations in small, closed spaces. The minimum
clearance around the IU0U automatic charger must be at least 25 cm (2,
page 3).
The air intake on the underside and the air outlet on the rear of the IU0U
automatic charger must be kept clear.
For ambient temperatures higher than 40 °C (such as in engine or heating
compartments, or direct sunlight), the heat from the IU0U automatic
charger under load can lead to the automatic shut-down.
The installation surface must be level and sufficiently sturdy.
All manuals and user guides at all-guides.com
Mounting the IU0U automatic charger
Explanation
Main switch
Mains connection
Cable with battery connection terminals
Fuse
Air outlet
Status LED
22