Home Decorators Collection ACKERLY 59210 Guía De Uso Y Mantenimiento página 7

Assembly - Standard Ceiling Mount
1
Preparation for standard mounting
☐ Remove the canopy ring (GG) by turning the ring counter-
clockwise until it unlocks.
☐ Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (EE) located in the "L
shaped" slots.
☐ Remove and save the two canopy screws (FF) in the round
holes. This will enable you to remove the mounting bracket (A).
EE
3
Assembling the fan
CAUTION: To ensure wobble-free operation and to
avoid damage to the fan, the downrod (B) and the
setscrew (JJ) must be completely tightened.
NOTE: This fan is equipped with a safety tab (HH).
Should the setscrew (JJ) ever become loose while
the fan is running in reverse, the safety tab (HH) will
engage and stop the fan from falling.
☐ Loosen, but do not remove, the setscrew (JJ) on the collar
(II) on top of the fan-motor assembly (E).
☐ Install the downrod (B) by inserting it into the motor collar
(II), and turning it clockwise until it is tight.
☐ Re-tighten the setscrew (JJ) on the collar (II) on top of the
fan motor assembly (E).
2
Routing the wires
☐ Route the wires exiting the top of the fan-motor assembly
(E) through the canopy ring (GG).
☐ Insert the ball/downrod (B) through the canopy (C) and
slide the decorative motor collar cover (D) onto the end of
the ball/downrod (B). Make sure the slots on the canopy
(C) are on top.
☐ Route the wires exiting the top of the fan motor assembly
(E) through the downrod as shown.
A
FF
C
GG
7
JJ
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
C
GG
B
D
E
B
HH
II
E