To Remove The Cutting Deck - Husqvarna R 316TX Manual De Usuario

7. Lift the front edge of the cutting deck and move it
into the equipment frame. The plugs on the cutting
deck, one on each side, must be put in the grooves
on the equipment frame. The service lock releases
automatically.
A
8. Lift the cutting height stay from the stay holder and
put it in the hole for the cutting height stay (A).
A
9. Put the drive belt around the tension wheel (B).
10. Put the spring in the spring holder (C).
11. Set the lift lever for the cutting deck in locked
position. The cutting deck lifts.
12. Attach the front cover.

To remove the cutting deck

To attach the cutting deck on page
1. Do steps 1–4 in
88 .
844 - 002 -
C
B
2. Release the clip on the front cover with the tool
attached to the ignition key, and remove the cover.
3. Loosen the tension on the tension wheel for the drive
belt. (A)
C
B
4. Hold the spring handle with your left hand and
remove the drive belt with your right hand.
5. Pull the drive belt to the rear below the product. Do
not put it in the belt holder (B).
6. Put the spring handle in the spring holder to prevent
that the spring falls down.
7. Lift the cutting height stay and put it in the holder for
the cutting height stay (C).
8. Hold the front edge of the cutting deck with two
hands and pull until it stops.
A
89