To Remove The Cutting Deck - Husqvarna R 418Ts AWD Manual De Usuario

2. Apply the parking brake.
3. Set the cutting height lever in the servicing position.
4. Set the lift lever for the cutting deck in the mow
position.
5. Push the equipment frame (A) down. Lift the
equipment frame lock (B) to vertical position.
WARNING: The lock mechanism can
cause injury to fingers if you do not
operate it carefully. Put the equipment
frame lock in full vertical position.
6. Remove the drive belt and put it in the belt holder.
7. Push the cutting deck into the equipment frame.
Make sure that the front guide plugs go in the
grooves on the equipment frame. The equipment
frame lock releases automatically.
12
A
B
8. Push the cutting deck in until the rear guide plugs
touch the bottom of the grooves on the equipment
frame.
9. Set the lift lever for the cutting deck in locked
position. The cutting deck lifts.
10. Attach the cutting height stay. Put the drive belt
around the drive wheels. Make sure that the drive
belt is on the correct side of the tension wheel.
11. Put the spring in the spring holder.
12. Attach the front cover.

To remove the cutting deck

1. Park the product on level ground.
2. Apply the parking brake.
3. Set the cutting height lever in the servicing position.
522 - 002 -