To Attach The Cutting Deck Combi 132 X, Combi; To Remove The Cutting Deck - Husqvarna P 520D Manual De Usuario

19. Pull the spring (A) and attach to the lift eyes on the
cutting deck (B).
B
20. Do a check of the parallelism of the cutting deck.
To do a check of the parallelism of the
Refer to
cutting deck on page 128 .
To attach the cutting deck Combi
132 X, Combi 155 X
To attach the cutting deck Combi
1. Obey step 1-20 in
132, Combi 155 on page 112 .
2. Pull the hydraulic hoses from the cutting deck
through the loop.
3. Attach the hydraulic hoses to the coupling on the
product.
Note: The operating function of the cutting height
lever is specified by the hydraulic hoses. To change
the operating function of the cutting height lever,
change the position of the hydraulic hoses.
114
A

To remove the cutting deck

1. Park the product on level ground.
2. Combi 132 X, Combi 155 X Release the couplings
and disconnect the hydraulic hoses.
3. Apply the parking brake.
4. Set the cutting height lever in the service position.
5. Stop the engine.
6. Pull the spring (A) and remove the lifting eyes (B).
7. Start the engine.
8. Set the lift lever for the cutting deck in the temporary
mow position (B).
B
A
WARNING: Do not put the lift lever to
mow position (A). Hydraulic force can
cause serious injury.
9. Stop the engine.
B
A
D
C
740 - 002 -