4. Align the pipes on the cutting deck with the pipes on
the equipment frame.
5. Hold the cutting deck with two hands and push it in.
6. Push until the pipes and the bolts touch the bottom.
Make sure that the lock is engaged.
7. Connect the 2 cables to the cutting deck.
16
8. Set the cutting height lever in a position between 1–
5.
To remove the cutting deck
1. Park the product on level ground.
2. Apply the parking brake.
3. Set the cutting height lever in the servicing position
(S).
4. Put the lift lever for the cutting deck in operation
position.
5. Disconnect the 2 cables to the cutting deck.
1263 - 006 - 27.04.2022