Tuner; Listening To The Radio - Pioneer SUPER TUNER III KEH-P7025 Operación Manual

Tuner

Listening to the radio

1
These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on page 12.
Important
If you are using this unit in North, Central or
South America, reset the AM tuning step (see
Setting the AM tuning step on page 31).
1
( ) indicator
STEREO ST
Shows that the frequency selected is being
broadcast in stereo.
2
indicator
BAND
Shows which band the radio is tuned to, AM
or FM.
3
indicator
PRESET NUMBER
Shows what preset has been selected.
4
indicator
FREQUENCY
Shows to which frequency the tuner is
tuned.
1 Press to select the tuner
SOURCE
Press until you see
SOURCE
2 Use to adjust the sound level.
VOLUME
Rotate to increase or decrease the volume.
3 Press to select a band
BAND/ESC
Press until the desired band is dis-
BAND/ESC
played, , , for FM or
FM1 FM2 FM3
All manuals and user guides at all-guides.com
2 3
4
.
displayed.
Tuner
.
.
AM
4 To perform manual tuning, press 2 or 3
with quick presses.
The frequencies move up or down step by step.
5 To perform seek tuning, press and hold 2
or 3 for about one second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
• You can cancel seek tuning by pressing either
2 or 3 with a quick press.
• If you press and hold 2 or 3 you can skip
broadcasting stations. Seek tuning starts as
soon as you release the buttons.
Note
• When the frequency selected is being broad-
cast in stereo the
STEREO (
light.
Section
03
ST indicator will
)
En 11