Selecting The Brightness; Setting The Rear Output And Subwoofer Controller - Pioneer SUPER TUNER III KEH-P7025 Operación Manual

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Section
Initial Settings
07

Selecting the brightness

You can select the display brightness. Initially
this mode is set to 12.
1 Press
FUNCTION
Press
FUNCTION
appears in the display.
2 Select the desired brightness with 2/3.
• The display shows
Setting the rear output and sub-
woofer controller
This product's rear output (rear speaker leads
output and RCA rear output) can be used for
full-range speaker (
(
) connection. If you switch rear
Rear SP:S.W
output setting to the
nect a rear speaker lead directly to a subwoofer
without using an auxiliary amp.
Initially, the unit is set for rear full-range speaker
connection (
Rear SP:FULL
When rear output are connected to full range
speakers (when
Rear SP:FULL
can connect the RCA subwoofer output to a
subwoofer. In this case, you can select whether
to use the subwoofer controller's (low pass
filter, phase) built-in
auxiliary
S.W Control:EXT
32
En
All manuals and user guides at all-guides.com
to select
.
BRIGHT
repeatedly until
Brightness
.
0
15
) or subwoofer
Rear SP:FULL
, you can con-
Rear SP:S.W
).
is selected), you
or the
S.W Control:INT
.
Notes
• Even if you change this setting, there is no
output unless you switch the non fading out-
put (refer to page 28) or subwoofer output
(refer to page 27) in the audio menu on.
• If you change the subwoofer controller, sub-
woofer output and non fading output in the
audio menu return to the factory settings.
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting mode.
1 Press
to select
FUNCTION
Press
repeatedly until
FUNCTION
appears in the display.
2 Change the rear output setting with 5/∞.
Pressing 5/∞ will switch between
(full-range speaker) and
:FULL
(subwoofer) and that status will be displayed.
Notes
• When no subwoofer is connected to the rear
output, select
Rear SP:FULL
• When a subwoofer is connected to the rear
output, set for subwoofer
• When the rear output setting is
you cannot change the subwoofer controller.
3 Change the subwoofer controller with
2/3.
Pressing 2/3 will switch between
and
:INT
S.W Control :EXT
be displayed.
.
SW
Rear SP
Rear SP
Rear SP :S.W
.
.
Rear SP:S.W
,
Rear SP:S.W
S.W Control
and that status will

Publicidad

Tabla de contenido
loading

Tabla de contenido