Using Compression And Bass Emphasis; Audioadjustments; Introduction Of Audio Adjustments - Pioneer SUPER TUNER III KEH-P7025 Operación Manual

Multi-CD Player
Using compression and bass
emphasis
You can use these functions only with a multi-CD
player that supports them.
Using COMP (compression) and DBE (dynamic
bass emphasis) functions let you adjust the
sound playback quality of the multi-CD player.
Each of the functions have a two-step adjust-
ment. The COMP function balances the output
of louder and softer sounds at higher volumes.
DBE boosts bass levels to give playback a fuller
sound. Listen to each of the effects as you select
through them and use the one that best
enhances the playback of the track or CD that
you are listening to.
1 Press to select
FUNCTION
Press until
FUNCTION Comp/DBE
the display.
• If the multi-CD player does not support
COMP/DBE, is displayed when you
No Comp
attempt to select it.
2 Press 5 or ∞ to select your favorite setting.
Press 5 or ∞ repeatedly to switch between the
following settings:
— —
Comp OFF Comp 1 Comp 2
—
DBE 1 DBE 2
All manuals and user guides at all-guides.com
.
COMP
appears in
— —
Comp OFF
Audio Adjustments
Introduction of audio
adjustments
1
display
AUDIO
Shows the audio adjustments status.
Press to display the audio function
AUDIO
names.
Press repeatedly to switch between the
AUDIO
following audio functions:
(balance adjustment)—
Fad
adjustment)— (bass)—
Bass
(loudness)—
Loud Sub-W1
(non fading output on/off)—
(subwoofer2)/ (non fading output set-
Non Fad
ting)— (high pass filter)—
HPF
adjustment)— (automatic sound levelizer)
ASL
• When the subwoofer controller setting is only
, you cannot switch the
S.W Control:EXT
(Refer to page 32.)
• You can select the
Sub-W2
Subwoofer output is switched on in the
• When the subwoofer controller setting is only
, you can switch the non fading
S.W Control:EXT
output on/off mode. (Refer to page 32.)
• You can select the non fading output setting
mode only when non fading output is switched
on in the non fading output on/off mode.
• When selecting the FM tuner as the source,
you cannot switch to
SLA
• To return to the playback display, press
.
BAND/ESC
1
(equalizer curve
EQ
(treble)—
Treble
(subwoofer1)/
Non Fad
Sub-W2
(source level
SLA
.
Sub-W1
only when
.
Sub-W1
.
En
Section
06
23