PROPAIN Trickshot Manual De Instrucciones página 13

ADDITIONAL WORKSHOP TIPS
// MOUNTING THE REAR WHEEL
1
Remove the transport lock from the brake, making sure that
the brake lever is not pulled.
2
1. Insert the rear wheel into the dropout of the frame.
→ The brake rotor must be placed between the brake
pads.
→ Put the chain on the sprocket.
2. Tighten the nuts of the axle with 18 Nm.
3. IMPORTANT: After each removal and installation of the
rear wheel, the chain should be re-tensioned and the
rear wheel centered.
→ Follow the instructions for "Tensioning the chain" in
the assembly instructions