Publicidad
support@nextlevelracing.com
22
Uninstall the bolts securing the Rear and Front Base Member.
23
Remove the Base Members.
24
Install 2 x T-Nuts into the inner top channel of both the Left and Right Base Members.
PARTS:
• • NIL
PARTS:
• • NIL
PARTS:
• • 4 x FULL WIDTH T-NUTS
16
(
)
T-NUTS LOCATION
25
Slide the T-Nuts previously installed in step 24 to the marked location and align them with the holes
on the Motion Safety Step.
26
Bolt through and secure with M8 Bolts and Washers.
27
Align the threaded holes on the sides of the Front Traction Base Member and the Rear Traction Base
Members with the through holes on the Base Members.
Video Instruction: bit.ly/nlrbuild
PARTS:
• • MOTION SAFETY STEP
PARTS:
• • 4 x M8 16mm BOLTS
• • 4 x M8 WASHERS
PARTS:
• • TRACTION BASE MEMBERS
17
Publicidad
