Faber STILO STIL24SSV2 Instrucciones De Instalación página 13

1.
3
Place a bracket
ceiling or upper limit, aligning the center (notch) with the
vertical reference line
holes in the bracket.
2.
Place the second bracket
first bracket, at the height of the upper chimney section
supplied and aligning the center (notch) with the vertical line.
3.
Mark the wall at the centers of the holes in the bracket and mark
the point 1 and 2 for the Hood Body installation as shown(12
5/8" from the horizontal line and 4 9/16" from the vertical line).
4.
Drill ø 5/16" holes at all the center points marked (point
1,2,3,4,5,6) as shown.
on the wall as shown about 1/8" from the
D
and mark the wall at the centers of the
X
on the wall as shown, below the
D
C
C
D
x6
x6
13