Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
C-STRIP-B-LIN Series
2' OR 4' FIXTURE INSTALLATION- DIRECT MOUNT
1.
Detach the LED assembly by starting at one end of the fixture and
pressing each side of the base. Pull the LED assembly away from
the base. Continue this along the entire fixture until the base and
LED assembly are separated. See Figure 4.
2.
After separating the base and LED assembly, disconnect the quick
connect. Set the LED assembly aside until the base is mounted
and wired. See Figure 5.
3.
Remove the appropriate knockout and feed the supply wires into
the housing. Install the fixture base to the mounting surface using
customer supplied hardware appropriate for the mounting surface.
Pass mounting hardware through (2) keyhole slots on the ends of
the base. See Figure 6.
4.
With the fixture base installed, make wiring connections per the
appropriate wiring diagram in the Electrical Connections section.
NOTE: If using the occupancy sensor accessory, please refer
to OCCUPANCY SENSOR ACCESSORY section for installation
and programming of occupancy sensor before proceeding to the
Electrical Connections section.
5.
For 2' fixture, select desired CCT. For 4' fixtures, select desired
wattage and CCT. See Figure 7.
6.
Reconnect the two halves of the quick connect that were
disconnected in Step 2. See Figure 8 on the next page.
7.
Reattach the LED assembly to the fixture base. The LED
assembly should "click" into place. See Figure 9 on the next
page.
8.
Supply power to fixture.
FIGURE 7
http://lighting.cree.com/warranty
Document:
LPN00625X0001A1
Created By:
TMT
FIGURE 4
FIGURE 5
FIGURE 6
|
866.924.3645
Date:
07-17-2021
Publicidad
