Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
C-STRIP-B-LIN Series
2' OR 4' FIXTURE INSTALLATION- HOOK AND
CHAIN
(Requires use of C-STRIP-A-SK Accessory)
1.
Detach the LED assembly by starting at one end of the fixture and
pressing each side of the base. Pull the LED assembly away from
the base. Continue this along the entire fixture until the base and
LED assembly are separated. See Figure 4.
2.
After separating the base and LED assembly, disconnect the quick
connect. Set the LED assembly aside until the base is mounted
and wired. See Figure 5.
3.
Attach one supplied support chain to each supplied S-hook. To
prevent the connection from disengaging, use a pliers to crimp
closed the ends of the S-hooks inserted through chains. See
Figure 10.
4.
Attach the opposite ends of support chains to moulting surface
using customer supplied hardware. Mounting locations for chains
should be directly above the keyhole slots on the back of the
fixture base. Adjust chain lengths to allow proper suspension of
fixture. Make sure mounting surface and hardware can support the
weight of the fixture.
5.
Attach S-hooks to fixture base by routing S-hooks through keyhole
slots and out through holes next to slots. To prevent the fixture
from falling use a pliers to crimp closed the ends of the S-hooks
inserted into the base. See Figure 11.
6.
Remove the appropriate knockout from the base of the fixture and
route supply conduit or cord to knockout location. Attach conduit or
cord at knockout.
7.
With the fixture base installed, make wiring connections per the
appropriate wiring diagram in the Electrical Connections section.
NOTE: If using the occupancy sensor accessory, please refer
to OCCUPANCY SENSOR ACCESSORY section for installation
and programming of occupancy sensor before proceeding to the
Electrical Connections section.
8.
For 2' fixture, select desired CCT. For 4' fixtures, select desired
wattage and CCT. See Figure 7.
9.
Reconnect the two halves of the quick connect that were
disconnected in Step 2. See Figure 8.
10. Reattach the LED assembly to the fixture base. The LED
assembly should "click" into place. See Figure 9.
11. Supply power to fixture.
http://lighting.cree.com/warranty
Document:
LPN00625X0001A1
Created By:
TMT
FIGURE 8
FIGURE 9
FIGURE 10
FIGURE 11
|
866.924.3645
Date:
07-17-2021
Publicidad
