Philips FC8802 Manual Del Usuario página 9

Ocultar thumbs Ver también para FC8802:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 39
-
opening into the dust container (Fig. 3).
The robot uses a systematic cleaning strategy that consists of three cleaning patterns.
1
Straight pattern
2
Spiral pattern
3
Wall-following pattern
The robot uses these patterns in the following order:
1
A straight pattern, followed by a spiral pattern (Fig. 4)
2
A wall-following pattern, followed by a spiral pattern (Fig. 5)
When the robot has completed this sequence of patterns, it starts moving in straight lines again.
The robot continues to use this sequence of patterns to clean the room until the rechargeable
battery is empty, or until it is switched off manually.
-
These drop-off sensors are used to detect and avoid height differences. In some cases, depending on
difference in time. Therefore avoid using the robot in these situations or monitor it carefully (Fig. 6).
1
Unpack the side brushes.
2
Push the side brushes onto the shafts on the bottom of the robot (Fig. 7).
Note: Make sure you attach the side brushes properly. Press them onto the shaft until you hear them
lock into position with a click.
You have to insert the rechargeable battery before use.
1
2
3
4
connector (Fig. 10).
5
6
Note: Make sure the two cover latches slide into the appropriate holes in the housing of the robot.
been inserted properly (see chapter 'Using your robot', section 'Indicator signals and their meaning').
Charge the battery for at least 4 hours each time to ensure the rechargeable battery performs best
and has a long life. A fully charged battery gives you a cleaning time of approximately 50 minutes on
ENGLISH
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Fc8800Fc8802/01

Tabla de contenido