KPS DCM7000BT Manual Del Usuario página 7

MIN/MAX
MIN
Press
MAX
to exit the MINMAX mode
The MAX/MIN mode records the min and max input values.
When the input goes below the recorded min value or above the recorded max value,
the meter records the new value. Press Hold button to pause the recording.
Volt Seek
Press MIN/MAX button for over 2 sec. to enter / exit Volt Seek mode.
Press MIN/MAX button to switch high/low sensitivity.
The Volt Seek LED indicates the electric field. If the Volt Seek LED is not on, voltage
could still be present.
Smart Hold
The meter will beep continuously and the display will flash if the measured signal is
larger than the display reading by 50 counts.
(However, it can not detect across the AC and DC Voltage / Current).
MIN
MAX
MIN
Press
MAX
AC
V
Button > 2 sec
Sensor
position
Do not hold across this
line when sensing the
hazardous voltage.
Volt seek
2 Sec
! Warning
AC
A
HOLD
ZERO
06
MAX MIN
AC
V
Press
MIN
MAX
MAX
AC
Press
MIN
MAX
V
Press
MIN
MAX
MIN
AC
V
MIN
MAX
HOLD
HOLD
AC
A
EN