Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting
4. Mounting
Orientation
Each F4 IP is constructed of magnesium die-cast. This ensures each panel is stable and easy to install.
Each panel also has a convenient built-in handle located on the top and bottom, backside of the panel
along with two alignment conicals on the top. This combination enables you to easily pick up and
securely hold each panel while mounting and working with the panels.
The F4 IP can be assembled to provide any number of modular designs. The panels on the top can be
securely hung from a truss or other stable surface. Always hang in a safe position with adequate space for
ventilation, configuration, and maintenance.
Chauvet recommends following the general guidelines below.
•
When selecting an installation location, consider ease of access for operation and routine
maintenance.
•
Make sure to hang away from any flammable material, as indicated in the
•
Never mount in places where rain, extreme temperature changes, or restricted ventilation may
affect it.
•
Make sure that the structure and attachment points to which you are hanging the panels can support
the weight.
•
Make sure that all load-bearing hardware used can support the weight.
•
See the
Technical Specifications
Mounting Points
1
2
2
2
1
3
1. Threaded Mounting
Holes Size M12 (x4)
F4 IP User Manual Rev. 1
for the weight requirement of each F4 IP.
2
3
2. Male Speego
Connection
Safety Notes
section.
2
1
3
3
3
1
3. Female Speego
Connection
8
Publicidad
Tabla de contenido
