Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting
Rig Bar/Panel Assembly
Alignment Conical (x2)
Spring
Knob
Locking Bar
1.
Insert alignment conicals into the alignment holes and allow magnets to connect.
2.
Insert the Rig Bar Speego locking bars into the female Speego connections on the F4 IP.
3.
Twist the spring knob on the Rig Bar Speego by 90°, until it locks into place.
4.
Twist the tightening knob clockwise until F4 IP is secure to Rig Bar.
5.
To detach the Rig Bar from the F4 IP, reverse the previous steps.
• The alignment magnets on the F4 IP and F-Series Rig Bar are designed to
temporarily hold the weight of the panel to allow the user to properly align and
tighten the panel into place.
• Either side of the F4 IP with female Speego connections can attach to the F-Series
Rig Bar, but only the short side has alignment conicals and magnets. When
attaching the long side of the F4 IP to the Rig Bar, take care to ensure that the pixels
across the video assembly are aligned properly.
Warning! The magnetic attachments are not load-bearing, and are intended for
alignment assistance only. Do not release panel until the hanging hardware has been
fully secured.
F4 IP User Manual Rev. 1
Rig Bar
Locking Latch
Rig Bar Speego
Tightening
Knob
Alignment Magnets
Alignment Holes
Male Speego Connection
Bottom View
Top View
Rig Bar
Locking Tab
10
Publicidad
Tabla de contenido
