Typical F4 Ip Installation - Chauvet Professional F4IP Manual Del Usuario

Typical F4 IP Installation

9. Typical F4 IP Installation
Because a video wall system can include different components to provide a simple to complex modular
wall design, use the following steps as a general guide to get started.
Step 1
Open and examine the F4 IP road case to make sure you have received all products and accessories and
that each one is in good condition.
Step 2
Apply power and run the self-test for each F4 IP to ensure all LEDs and inside connections in each panel
are working (optional).
Step 3
Create a stable mounting surface (e.g., truss or other stable surface) for F4 IP mounting.
Step 4
Mount the first top row of the F4 IPs. Refer to the Mounting section in this User Manual.
Step 5
Adjust the alignment of the first row using the Speego connectors.
Step 6
Connect the signal source to the VIP Drive 43Nova.
Step 7
Connect the VIP Drive 43Nova to the Signal port of the first panel in your connection chain.
Step 8
Based on your video wall configuration (design), join each panel, either horizontally or vertically, using the
instructions in the section Joining Each F4 IP (Creating a Modular Design).
Refer to the instructions and information in the section of this User Manual, Connecting (Cabling) Each F4
IP.
F4 IP User Manual Rev. 1 26