Led Module Care And Replacement; F4 Ip Module; Led Lot Numbers; A And B Modules - Chauvet Professional F4IP Manual Del Usuario

LED Module Care and Replacement

7. LED Module Care and Replacement

F4 IP Module

Each F4 IP has 4 LED modules connected to the panel frame by magnets. Each module has a single
connector that connects to the main processing unit.

LED Lot Numbers

To ensure consistent color matching and output, replace damaged or defective modules with the same
LED lot # as the others on the panel. When combining panels to create full video wall systems (rentals,
permanent installations, etc.) it is highly recommended that the LED lot #'s on each of the panels match.
LED lot #'s can be located on the back of each module.
LED LOT #
Connector
Steel Plate

A and B Modules

The F4 IP has 2 types of modules, designed to only plug in to the Service Module from one direction.
Check the orientation of the LED LOT # label to determine whether the module is an A type (top half,
connector down) or a B type (bottom half, connector up).

Using MT-01

The MT-01 is specially designed to carefully remove and replace the F4 IP LED module from the front
while the panel is mounted in a video wall setup. Before using this tool, be sure that the magnet is drawn all
the way back to the home position by turning the knob clockwise. Failure to set the magnet to the home
position may result in damage to the module.
21 F4 IP User Manual Rev. 1