Connecting (Cabling) Each F4 Ip; Testing Signal And Power Connections; Using The F4 Ip Test Button - Chauvet Professional F4IP Manual Del Usuario

Connecting (Cabling) Each F4 IP

6. Connecting (Cabling) Each F4 IP

Testing Signal and Power Connections

Each F4 IP has 2 power sockets and 2 signal ports.
• The Power and Signal connections are located on the underside of the service module of each
panel.
• The Signal ports may be used interchangeably.
• Each F4 IP has LED indicator lights on the test button in the center of the panel.
• Each panel indicates a successful power connection when the Power indicator light remains red.
• Each panel indicates the presence of a signal when the Signal LED indicator light blinks green
quickly. When the LED blinks green slowly, there is no signal.
Rear Panel View

Using the F4 IP Test Button

Each F4 IP has a Test button, used to ensure all LEDs are functional. Use the Test button on each panel to
perform a self-test. If self-testing, you must perform the test individually for each F4 IP. You do not need to
connect to a signal or use software.
When using the Test button, make sure the F4 IP is NOT connected to the
VIP Drive 43Nova.
To use the Test button, you must connect the power, but do not connect the signal cables. Press the Test
button to toggle through various LED light display configurations.
F4 IP User Manual Rev. 1
Underside of Service Access View
Test Button
Power/Signal
Indicator LEDs
Signal Connections
Power In/Out
18