Celestron STARSENSE EXPLORER 10 DOBSONIAN Guía De Configuración Rápida página 5

9
A1
A2
L1
9. Install the altitude bearing cylinders (L1) onto the left and right
side panels (A1 & A2) with the altitude bearing screws (L2).
The bearings go on the interior surfaces of the side panels. The
end of the bearing with no bevel on it should be fl ush to the
surface of the panel.
11
O
11. Place the optical tube assembly (O) onto the assembled
Dobsonian base. The side hubs on the tube should sit on the
altitude bearing cylinders on the base.
10
L2
10. Attach the rubber bumper (M) to the interior surface of the
front panel (B). There is a small spot on the front panel that
indicates where to place the rubber bumper. Remove the
adhesive backing from the bumper and press the bumper fi rmly
onto the spot.
12
12. Install the altitude tensioning knob (N1) through the slot in the
left side panel (A1) and into the threaded insert in the center of
the side hub on the optical tube assembly.
B
N1
M
A1
ENGLISH I 5