Replacing The Remote Control Battery; Troubleshooting - EQUATION AC-1 Manual De Instrucciones

Replacing the remote control battery

1 - Remove the screw using a screwdriver
2 - Push the battery compartment fl ap to remove it.
3 - Insert 1 CR2032 / 3V battery in the compartment with the "+" facing up.
4 - Replace the battery compartment cover.
5 - Tighten the screw
Important!
• Do not let children play with the batteries
• Do not ingest the batteries
• Non-rechargeable batteries should not be recharged;
• The battery must be inserted with the correct polarity (see diagram);
• An old or leaking battery should be removed from the device and disposed of safely;
• If the device will not be used for a long time, remove the battery;
• The battery contacts must not be short-circuited;
• The battery must be removed from the device before disposal.

TROUBLESHOOTING

Malfunctions are often due to minor causes; consult the table below before contacting the after-sales service. This can save you
time and avoid unnecessary expenses.
Problem
The device does not work
The remote control does not work
The room is not cooled
The device vibrates abnormally
In the event of a persistent problem, contact the after-sales service of your store.
Causes, solutions
Check the power supply.
Check the fuse.
Check the battery
Check that the "Cooling" mode is active
Check for good air circulation at the inlet and outlet
Check that the fi lter is clean and not clogged
Check that the setpoint temperature is lower than the ambient temperature
Check that the doors and windows are properly closed
Check that it is installed on level and stable ground.
FR
ES
PT
IT
EL
PL
UA
RO
EN
47