EQUATION AC-1 Manual De Instrucciones página 43

INSTALLATION
Choose a location that meets these criteria:
• The ground must be fl at and stable
• A distance of 50 cm between the walls and the appliance must be
respected
• The device must be plugged into a wall outlet which must remain
accessible once the device is plugged in.
• It is essential to connect the external exhaust for use in cooling mode or
in dehumidifi cation mode
Connection of the exhaust duct
Connection is mandatory for use in Cooling or Dehumidifi cation mode,
but not necessary in Ventilation mode.
The exhaust duct can be connected into a wall or installed to a window.
1 - Fix adaptor A (device connection) on the pipe
2 - Fix adaptor B (window connection) on the pipe if necessary
3 - Clip adaptor A onto the device
4 - Connect the hose to the outside outlet.
A
Install the Window Slider Kit (for sliding windows)
1 - Cut the adhesive foam seal
D to the correct length and
secure it to the window sash.
2 - Attach the window slider kit
to the window sash. Adjust
the length of the Window
Slider Kit, then tight the
screws. The length of the
Window Slider Kit is 67.5cm
to 120cm.
3 - Caulk the empty part
between the two windows
using the foam gasket E (non
adhesive)
4 - Clip adaptor B onto the
window kit
C
1
D
2
3
E
220-240V
50Hz
B
D
E
A
4
FR
ES
PT
IT
EL
PL
UA
RO
EN
43