Hansgrohe AXOR Carlton 17615 Serie Instrucciones De Montaje página 7

Assembly
Attention! The fitting must be installed, flushed and
tested after the valid norms.
Operation
The mixer is actuated by lifting the lever head.
Move to the left = hot water,
move to the right = cold water.
Technical Data
Operating pressure:
Recommended operating pressure: 0.1 - 0.5 MPa
Test pressure:
(1 MPa = 10 bars = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Rate of flow by 0.3 MPa:
Test certificate
10615000/17615XXX/
36615000/37655XXX:
Hansgrohe single lever mixers can be used toge-
ther with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0.15 MPa.
To adjust the hot water limiter on single lever mixers,
please see page 14.
No adjustment is necessary when using a continuous
flow water heater.
Fault
Mixer stiff
Mixer dripping
Hot water temperature too low, no
cold water.
Instantaneous water heater starts
up when cold water is selected.
English
max. 1 MPa
1,6 MPa
max. 80° C
65° C
approx. 32 l/min
WRAS
Cause
- Cartridge defective, calcified
- Cartridge defective, sedimenta-
tion
- Hot water limiter incorrectly set
- Crossflow
Spare parts (see page 3)
1 handle Starck
1.1 screw cover
2 handle Carlton
3 handle Allegroh
4 handle Terrano
4.1 screw cover
5 handle Steel
5.1 screw cover
6 handle Massaud
7 face plate
8 face plate Massaud
9 flange
10 flange Terrano
11 flange Massaud
12 nut
13 locking screw for handle
14 seal
15 o-ring 13x2
16 noise reduction
17 cartridge cpl.
18 sub plate
19 fixing screw
20 extension 25 mm
21 extension 22 mm
XXX = Colors
000 chrome plated
090 chrome plated/gold plated
120 chrome plated/porcelain colour
800 steel
810 satinox
880 satin chrome
Remedy
- Exchange cartridge
- Exchange cartridge
- Set hot water limiter
- Exchange seal (1)
10492000
96338000
17092XXX
36093000
37491XXX
96347000
35093800
96681000
18492000
96452XXX
98678000
95010XXX
96348XXX
98684000
95007000
96059000
95008000
98128000
94073000
92730000
96447000
96454000
13595000
13596XXX