General Warnings - GET ECULMB RACE KIT Guia De Instalacion

ENGLISH
A. WARNINGS FOR CORRECT USE
Read all the instructions and warnings carefully before
using GET Eculmb Race Kit. Failure to read and/or observe
the instructions and warnings can lead to incorrect use of
the device or its malfunction, resulting in product damage
and personal injuries.
GET ECULMB RACE KIT IS INTENDED ONLY AND
EXCLUSIVELY FOR RACING USE.

GENERAL WARNINGS

1. Follow the instructions described in this manual to prevent
vehicle damages.
2. Do not modify or replace the material supplied by GET.
3. Always make sure that no installed part can interfere with
the hot parts of the engine, the steering components or with
the rider.
4. The product is not a toy. Keep it out of the reach of children
and/or animals as it contains small sized components that
could be swallowed.
5. Do not use the product for purposes other than those
specified in these instructions.
6. Do not use high pressure washers on the product.
SPECIFIC WARNINGS
1. Always make sure that GET ECULMB is properly installed
and functional prior to use.
2. Never expose the device to temperatures above
70°C/158°F.
3. Install it when the engine is cold.
EN 2
4. When GET ECULMB is installed, if an OEM air filter and/or
and OEM exhaust system are not installed on the bike, this
could lead the engine to lose power. To fully exploit engine
performance, use only original air filter and exhaust system.
5. To use and manage the GPA technology, it is necessary
to install GET GPA Switch or GET LC-GPA module (both sold
separately) or manage it with GET Maya Software (sold
separately).
6. To change GET ECULMB injection map, it is necessary to use
GET Maya programming software (sold separately).
7. If the bike does not start or the engine is irregular, be sure
that the version of GET ECULMB chosen is compatible with
your bike model and year. Verify that ECULMB is properly
connected and perform a TPS calibration (see section F.
TUNING - ZERO TPS CALIBRATION).
8. Do not remove the thermostatic valve: removing it may
cause damage and/or malfunction.
9. Keep the exhaust control OEM setting measurement to
avoid engine malfunctions:
300cc engines: 2,3 mm (0.091")
250cc engines: 2,7 mm (0.106")
10. Use only OEM spark plugs to avoid engine malfunctions.
Check the proper spark plug model on your vehicle manual.
11. Periodically check the engine compression ratio (see your
motorcycle manual) to avoid malfunctions and to fully exploit
GET performance kit.
3 EN