GET ECULMB RACE KIT Guia De Instalacion página 7

It is possible to use GET WiFi-COM both with the engine on or
with the engine switched off. In the latter case, it is mandatory
to use the Wake-up connector, which is included as part of the
motorcycle's separate enclosure. Remove the protection cap
from the motorbike's diagnostic connector and connect the
Wake-up connector. The OEM diagnostic connector can be
found near the motorcycle battery: check on the workshop
manual where to find it.
ATTENTION: Remember to remove the Wake-up
connector after the use to avoid discharging the battery.
ATTENTION: Maps are editable only with GET
ECULMB firmware MB2TPI07 or newer versions (e.g.,
MB2TPI08, MB2TPI09). Check the ECULMB firmware
with GET WiFi-COM provided in the kit. Open the
menu in WiGET app, select "SYSTEM INFO" and check
the value "Fw Code", which is the firmware code of the
connected GET ECULMB.
F. TUNING
IDLE REGULATION
ATTENTION: For M.Y.
HUSQVARNA updated both OEM EFI calibration and
idle screw regulation. See section F. TUNING - ZERO
TPS CALIBRATION – with GET WiFi-COM, to verify if
it is necessary to update your GET ECULMB firmware
and to modify the idle screw setting.
For the best idle speed, it is necessary to perform the idle
regulation. This operation influences the vehicle starting
behavior, a stable idle speed and the vehicle's response when
the throttle is opened. The engine may go out spontaneously if
the idle speed is set too low. An incorrect idle speed can have a
negative impact on overall engine running.
EN
2018-2019, KTM and
12
ATTENTION: Before starting the idle regulation
procedure, make sure the emergency OFF switch is
in run position and the throttle is completely closed.
Make the setting in small steps.
1.
Find the idle screw on the throttle valve body on the left
side of the bike, between the airbox and the intake manifold.
Otherwise, check on your motorbike's workshop manual
where to find it.
2.
Turn the idle screw clockwise to decrease the idle
speed and to start the tuning.
Turn it counterclockwise to increase the idle speed:
• For MY 2018/2019
counterclockwise for 2,5 turns.
• For MY 2020/2022
counterclockwise for 4,5 turns.
3.
If you encounter any engine irregularities after a
correct idle regulation, GET suggests performing the
ZERO TPS Calibration (see following section).
ZERO TPS CALIBRATION
Zero TPS Calibration allows GET ECULMB to properly recognize
when the throttle is completely closed, and to ensure accurate
readings of the fuel level injected into the combustion
chamber. When installing a new ECU or other accessories,
GET recommends carrying out the Zero TPS Calibration. This
calibration will ensure a correct fuel calculation, so the motorbike
can accelerate accurately, and it will avoid poor fuel economy.
bikes, rotate the screw
bikes,
rotate the screw
13 EN