GET ECULMB RACE KIT Guia De Instalacion página 5

4.
Remove the injectors
from the fuel distributor
and place them on GET
injector support. Place
the spacers provided
in the kit between the
red brackets and the
OEM injector brackets.
Fix the OEM injector
brackets together with
the spacers and the red
injector support brackets
using the four M5x25mm
screws provided in the kit.
5.
Disassemble the previously removed fuel distributor
in 7 parts: 3-way fitting, supply hose, 2 injector fuel hoses,
2 injectors, fuel line pump plug.
6.
Using the OEM 3-way fitting assemble a new fuel
distributor. Remove the OEM right injector fuel hose ("B",
the longest hose) and replace it with the OEM supply hose
"C". The OE right injector fuel hose "B" will not be used. Install
GET fuel hose as the new supply hose, while the left injector
fuel hose "A" remains in the same position. Insert the fuel line
pump plug into the left injector fuel hose "A". Insert the right
OEM injector into GET fuel hose, insert the left OEM injector
into "C" fuel hose. Fix all the connections using hose clamps.
A B
L R
C
EN
A C
L
GET
hose
8
7.
Connect the injector fuel hoses to the injectors. Use
hose clamps to fix them.
8.
Fix GET injector
support and the OEM
intake flange with the
four M6x30 mm provided
screws. Assemble them
to the engine case
placing the intake flange
gasket, included in the
kit, between them.
9.
Re-install the injectors' harness, the throttle valve
body, the upper engine mount brackets. Put the rear
subframe back in the original position. Plug the fuel line
pump plug and the fuel pump connector to the fuel tank.
Fix the fuel tank and install the exhaust system.
9 EN