Makita GVP01 Manual De Instrucciones página 10

NOTE: The loop handle can be laid down back and
forwards according to your preferred position. Loosen
the hex bolts, move the handle to your desired angle
and then refasten the bolts to lock the angle.
1
Fig.11
► 1. Loop handle 2. Hex bolt
Installing side grip
CAUTION:
Be sure to hold the tool firmly with
both hands, positioning one hand on the switch
handle and the other on the loop handle, side grip
or tool head.
CAUTION:
Make sure that the side grip is
installed securely before operation.
Screw the side grip tightly into the mounting hole on
either side of the tool head.
Fig.12
► 1. Mounting hole 2. Side grip
2
1
2
10 ENGLISH
Installing and removing wool pad
Optional accessory
CAUTION:
Make sure that the backing pad is
secured properly. Loose attachment will run out of
balance and cause an excessive vibration which may
cause loss of control.
CAUTION:
Make sure that the wool pad and
backing pad are aligned and securely attached.
Otherwise the wool pad will cause an excessive vibra-
tion which may cause loss of control or the wool pad
may be thrown out from the tool.
CAUTION:
Only use the hook-and-loop sys-
tem wool pads for polishing.
NOTICE:
Never actuate the shaft lock when the
spindle is moving. The tool may be damaged.
NOTICE:
Regularly clean accessories and spin-
dle to remove dust and debris. Wipe the compo-
nents clean with a cloth dampened in soapy water if
necessary.
1
2
3
4
Fig.13
► 1. Wool pad 2. Sleeve 18 3. Backing pad 4. Spindle
Installing wool pad
1. Press in the shaft lock to prevent spindle rotation,
and thread the backing pad into the spindle.
2. Hand tighten the backing pad securely.
3
1
Fig.14
► 1. Shaft lock 2. Backing pad 3. Spindle
2