Filling The Water Tank - ProBreeze PB-AC06 Manual De Instrucciones

Humidification Mode
Humidification can be activated in any of the
modes above. When activated, the device will
evaporate water from the water tank; reducing
the temperature of the air to create a more
refreshing experience in hot, dry conditions.
For an even cooler experience, add the ice
packs (included) to the water tank.
• Before activating this mode, ensure there
is sufficient water in the water tank as per
the instructions below.
• Press the humidification button on the
control panel or remote control to activate
this mode. A water drop symbol will
appear on the display panel.
• If the water drop symbol flashes, there is
insufficient water in the tank. Fill as per
instructions below.
• Press the humidification button again to
turn off Humidification Mode.
Timer Button with Control Panel
You can schedule your device to automatically
turn on or off using the Timer Button on your
control panel or remote control.
To schedule your device to turn on:
1. Ensure the appliance is plugged in and the
power socket is turned on.
2. Press the timer button and use the increase
and decrease buttons to set when you
would like to device to turn on (starting at
half an hour and up to 10 hours).
3. Select the desired settings that you
would like the unit to revert to when it
automatically switches on using the mode,
humidification, and increase & decrease
buttons.
4. The LED display will blink for around 8
seconds on the desired setting. It will then
display your desired setting for 1 minute
before turning off until your scheduled time
is reached.
5. To cancel the turn-on timer press the
power button twice.
Note: To set a turn-on timer with remote
control, simply follow the above steps 1 to
6 | English
5 but use the timer button itself to increase
the desired turn-on time.
Setting a turn-off timer:
1. Ensure the appliance is plugged in and the
power socket is turned on.
2. Press the power button to turn the
appliance on.
3. Press the timer button and use the increase
and decrease buttons to set when you
would like to device to turn off (starting at
half an hour and up to 10 hours).
4. The LED display will blink for 2 seconds to
confirm a timer has been set.
5. To cancel the turn-off timer press the timer
button and use the increase and decrease
buttons to set until timer indicator lights are
showing '0.0' or turn the appliance off.
Note: To set a turn-off timer with remote
control, simply follow the above steps 1 to
5 but use the timer button itself to increase
the desired turn-off time.

FILLING THE WATER TANK

For the humidification mode to function the
water must be above the "min" mark on the
water tank. Ensure fresh water is added to the
water tank prior to every use.
To fill the water tank:
1. Turn off the appliance and unplug it from
the power socket.
2. Unclip the lock and pull the water tank
out gently with both hands. Caution: the
water tank is connected to the device.
Do not force the water tank out.
3. On the base of the water tank, there is a
clip that connects the filter to the tank.
Turn the clip 90 degrees anticlockwise and
disconnect the filter from the water tank.
4. Fill the water tank to the max line with
fresh water.
5. Slowly push the water tank halfway back
into the unit and re-attach the filter using
the clip lock clockwise.