Makita VC001GL Manual De Instrucciones página 12

Spread the other top edges of the bag outwards over
the top rims of the tank. Place the cloth filter or prefilter
over the polyethylene bag to fasten the opening of the
bag securely.
Fig.17
► 1. Cloth filter / prefilter
NOTE: A polyethylene bag available on the market
can be used. 0.04 mm or thicker one is recommended.
NOTE: Too much dust will tear the bag easily, so do not
collect the dust more than the half of the bag capacity.
Emptying tank with polyethylene bag
WARNING:
Always make sure that the cleaner
is switched off and the battery cartridges are
removed before emptying the tank. Failure to do so
may cause an electric shock and serious personal injury.
NOTICE:
Do not apply a great impact on the float
cage and tank. Applying a great impact may cause
deformation and damage to the parts.
NOTICE:
Empty the tank at least once a day
although this depends on picked-up dust volume
in the tank. Or, the suction force will weaken and the
motor may be broken.
NOTICE:
Do not grab the hooks or latches when
emptying the tank. Grabbing the hooks or latches
may cause them to break.
Release the locking latches and lift the head unit up off the tank.
Shake off dust from the cloth filter or prefilter before
lifting the filter away from the tank.
Then remove the polyethylene bag out of the tank,
closing the opening of the bag by hand.
1
2
Fig.18
► 1. Polyethylene bag 2. Tank
1
12 ENGLISH
NOTE: Take the polyethylene bag out of the tank
carefully to avoid it from being scratched and torn by
the edges inside the tank.
NOTE: Empty the polyethylene bag before it
becomes full. Too much dust in the tank may cause
the polyethylene bag to be torn.
Installing multi hook
Use the multi hook to hold a hose, accessories and
attachments not in use in place, and you can quickly
take them out according to your preferences.
Fig.19
Place the multi hook over the mounting base at the rear
of the cleaner, setting the rails on the multi hook along
the grooves on the mounting base.
1
Fig.20
► 1. Multi hook 2. Mounting base
2