VALBERG FIH 60 EGK 756C Instrucciones De Uso página 7

B
Using the appliance
Installation of the cookerhood
Drill 3 x 8 mm holes for hood holding bracket. Tighten the bracket with the screws and plugs
provided.
Wall holes
Screw plug
Wallbracket
Lift the hood up and hang it onto the wall bracket.
10
4 x 30 mm - screw
EN
B
Using the appliance
Open the glass panel and remove the aluminum grease filter. Mark the four holes for the installation
from the inside of the hood.
Take the hood back down again. Drill the four ø 8 mm holes at the marked locations. Insert four
wall plugs into the holes and four screws into the wall.
Hang the extractor hood back in the wall bracket and tighten the four screws on the inside of the
extractor hood.
11 EN